Onkyo TX-SR604/604E, TX-SR674/674E Setting the Powered Zone, Buttons to select Powered Zone

Zone 2—Continued

Setting the Powered Zone 2

To use Zone 2, you must make this setting. It enables the speakers connected to the ZONE 2 SPEAKERS termi- nals so that they produce sound when Zone 2 is used.

1	RECEIVER	Press the [RECEIVER] button fol-
		lowed by the [SETUP] button.
		The main menu appears onscreen.
SETUP
2		Use the Up and Down [ ]/[ ]

buttons to select “8. Hardware Setup,” and then press [ENTER]. The Hardware Setup menu appears.

3	Use the Up and Down [ ]/[ ]
	buttons to select “Powered Zone
	2,” and use the Left and Right
	[ ]/[ ] buttons to select:
	8.Hardware Setup
	------------------------
	a.SP Impedance :6ohms
	b.PoweredZone2:NotAct
	c.TV Format	:Auto
	d.AM Freq. Step: 9kHz
	e.Remote ID	:1
	f.HDMI Audio Out :Off
	g.SW Input Sensitivity
		: 0dB

Not Act: ZONE 2 SPEAKERS termi- nals deactivated.

Act: ZONE 2 SPEAKERS termi- nals activated.

When Zone 2 is activated and turned on (see page 81), the speakers connected to the ZONE 2 SPEAKERS terminals output sound, but the speakers con- nected to the SURROUND BACK SPEAKERS terminals do not (when Zone 2 is activated but not used, the surround back speakers work as nor- mal).

4	Press the [SETUP] button.
	The setup menu closes.
	SETUP

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

80