Using Advanced Sound Options
Adjustment Using Test Tone The test tone lets you balance the signal levels between all your speak- ers.
To turn on the test tone, press then press TEST TONE. The receiver sounds a
Note: The test tone sounds only for the speakers that you connected and activated as described in “Initial Setup.”
Press – CH LEVEL + while the test tone sounds for the speaker you want to adjust.
Press TEST TONE again to turn off this feature.
Dolby Digital Playback
When you want to play a source that has Dolby Digital audio signal, set the source to digital mode (see “Switching Analog/Digital Signal Input” on Page 23) and press . Then activate the source device. DOLBY DIGITAL appears on the display as the receiver receives the Dolby Dig- ital signals.
Note: When you connect a DVD/LD player that uses
DVD 5.1-Channel Playback
When you connect a
When you select this mode DSP mode, SIGNAL SELECT, ATT, DIRECT, TRE-
BLE, BASS, MIDNIGHT are disabled.
Using the Midnight Mode
You can compensate for the effect of sound deterioration at low listening levels to enjoy the surround sound of your favorite movie whenever you desire.
Press MIDNIGHT MODE (MIDNIGHT on the remote control) so MIDNIGHT appears on the display. Press the button again to disable this feature.
Program Format Indicators | The following indicators light to show the channels being played. |
| In |
| front), LS (left surround), and RS (right surround). |
| In Dolby Surround mode: L (left front), R (right front), and S (surround). |
27