Installation
Powering On/Off the Projector
Powering On the Projector
. Remove the lens cap.
2.Securely connect the power cord and signal cable. When con- nected, the Power LED will turn red.
3.Turn on the lamp by pressing “
” button on the side of the projec- tor or on the remote control. The Power LED will fl ash blue.
The startup screen will display in approximately 30 seconds. The fi rst time you use the projector, you can select your preferred lan- guage from quick menu after the startup screen display.
4.Turn on your source that you want to display on the screen (com- puter, notebook, video player, etc). The projector will detect the source automatically and will display on the screen. If not, push menu button and go to “SETUP”. Make sure that the “Source Lock” has been set to “Off”.
If you connected multiple sources at the same time, press the “Source” key on the remote control to switch between inputs.
1 | 2 |
NOTE |
| POWER |
|
|
|
| |
| Turn on the | LAMP | STANDBY |
| |||
| projector fi rst and | TEMP |
|
| then select the |
| |
|
|
| |
| signal sources. |
|
|
