Usage Notice
Precautions
Please follow all warnings, precautions and mainte- nance as recommended in this user’s guide.
NOTE
When the lamp reaches the end of its life, the pro- jector will not turn back on until the lamp module has been replaced. To replace the lamp, follow the proce- dures listed under “Replacing the Lamp” section.
▀■ Warning-
▀■ Warning-
▀■ Warning-
▀■ Warning-
▀■ Warning-
▀■ Warning-
▀■ Warning-
▀■ Warning-
▀■ Warning-
Do not look into the projector’s lens when the lamp is on. The bright light may hurt your eyes.
To reduce the risk of fi re or electric shock, do not expose this projector to rain or moisture.
Please do not open or disassemble the projec- tor as this may cause electric shock.
When replacing the lamp, please allow the unit to cool down.
This projector will detect the life of the lamp itself. Please be sure to change the lamp when it shows warning messages.
Reset the “Lamp Reset” function from the on- screen display “SystemLamp Setting” menu after replacing the lamp module.
When switching the projector off, please ensure the cooling cycle has been completed before disconnecting power. Allow 90 seconds for the projector to cool down.
Do not use lens cap when projector is in opera- tion.
When the lamp is approaching to the end of its life time, the message “Replacement sug- gested” will show on the screen. Please contact your local reseller or service center to change the lamp as soon as possible.
