Appendices

Other Problems

The projector stops responding to all controls

If possible, turn off the projector, then unplug the power cord and wait at least 20 seconds before reconnecting power.

Lamp burns out or makes a popping sound

When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the “Replacing the Lamp” section.

Remote Control Problems

If the remote control does not work

Check the operating angle of the remote control is within ±25° both horizontally and vertically of on of the IR receivers on the projector.

Make sure there are not any obstructions between the remote control and the projector. Move to within 6 m (20 ft) of the projector.

Make sure batteries are inserted correctly.

Replace batteries if they are exhausted.

45 English

Page 45
Image 45
Optoma Technology XX152 N manual Other Problems, Remote Control Problems, Projector stops responding to all controls