Contrast, Brightness, Sharpness, Color | Optoma Technology XX152 N

User Controls

NOTE

“Color” and “Tint” are only support- ed for composite and component sources.

Contrast

The contrast controls the degree of difference between the lightest and darkest parts of the picture. Adjusting the contrast changes the amount of black and white in the image.

Press the ◄ to decrease the contrast.

Press the ► to increase the contrast.

Brightness

Adjust the brightness of the image.

Press the ◄ to darken image.

Press the ► to lighten the image.

Sharpness

Adjust the sharpness of the image.

Press the ◄ to decrease the sharpness.

Press the ► to increase the sharpness.

Color

Adjust a video image from black and white to fully saturated color.

Press the ◄ to decrease the color saturation in the image.

Press the ► to increase the color saturation in the image.

Tint

Adjust the color balance of red and green.

Press the ◄ to increase the amount of green in the image.

Press the ► to increase the amount of red in the image.

English 28

Image 28

Optoma Technology XX152 N manual Contrast, Brightness, Sharpness, Color, Tint

Contents

Table of Contents Safety Information Important Safety InstructionClass B emissions limits English Precautions Do not Usage Notice Eye Safety Warnings Introduction Package Overview Product Overview Main Unit Connection Ports Remote Control Backup Remote Control Coin Cell Battery Replacement Installation Connect to Computer/Notebook Connect to Video Connect to 3D Video Devices PlayStation 3 Games 5 English Using the 3D glasses Powering On/Off the Projector Powering On the Projector Powering off the projector Adjusting the Projected Image Adjusting the Projector’s Height Adjusting Projected Image Position Using PureShift  Adjusting the horizontal image position Adjusting Projection Image Size  PureShift Range Diagram Remote Control User Controls From Hdmi 1 connector From Hdmi 2 connectorFrom VGA connector Than How to operate On-screen Display Menus Main Menu Sub Menu Settings Menu Tree Display Mode Image Contrast BrightnessSharpness Color Color Settings Noise ReductionGamma PureEngine PureDetail PureColorPureMotion PureEngine Demo Color Gamut Color TemperatureCMS Color Management System RGB Gain/Bias Color SpaceRGB Channel Use or to select from Normal, Red, Green or Blue channels Display Format Zoom Edge MaskImage Shift Keystone 3D Mode 3D 2D 3D Format 3D Sync. Invert Menu Location Lamp SettingProjection Test Pattern Background Color12V Trigger a 12V Trigger B User Controls Lamp Mode Lamp ResetLamp Hour Lamp Reminder Language Input SourceSource Lock High Altitude Signal Auto Power OffReset Troubleshooting Image Problems Image has slanted sides Image is reversedBlurry double image Two images, side-by-side format Other Problems Remote Control ProblemsIf the remote control does not work Projector stops responding to all controls Message Power LED Temp LED Lamp LED LED Lighting Messages  Power down timer active  Lamp warning  Power off On Screen Messages Replacing the Lamp Lamp Replacing Procedure Compatibility Modes  Computer Compatibility for PC  Computer Compatibility for MAC  3D Input Video Compatibility SBS RS232 Commands and Protocol Function List RS232 Pin Assignments RS232 Protocol Function List UART16550 Fifo Setup Ceiling Mount Installation Optoma Global Ofﬁces Deutschland ScandinaviaKorea Japan Regulation & Safety Notices FCC NoticeOperation Conditions Remarque à l’intention des utilisateurs canadiens Declaration of Conformity for EU countries Disposal instructions