GB
SET THE SEA-LEVEL PRESSURE
Sea level pressure can change relative to location. To achieve accurate altitude readings, set the
Diagram | Instructions | |
| 1. | While in |
|
| the SEA (sea pressure) screen is shown. |
| 2. | Press and hold FUNC/SET for two seconds, then |
|
| use SELECT/+ or ST/SP/- to change the value. |
|
| The value will change in increments of 1 hPa or |
|
| .03 inHg, depending on the measurement unit you |
|
| selected in CLOCK Mode (see CLOCK mode). |
| 3. | Press FUNC/SET again when finished. |
NOTE The altitude reading will change according to the sea level pressure adjustment.
VIEW THE SEA-LEVEL PRESSURE
To view a graphical image of the current sea level pressure reading, press FUNC/SET with the SEA screen shown in
SET ALTITUDE ALERT
The watch can be set to remember an altitude limit (either up or down, but not both simultaneously). If the alarm is activated, a series of beeps (at 5 second intervals) will sound, and the mode bar will blink, when you breach the limit. To end the alert, press any button.
To set the alert limits and activate or deactivate the alert:
Diagram | Instructions | |
| 1. | PressSELECT/+ until you reach the Alarm screen. |
|
| (Display reads 'AL' or 'NoAL' at the bottom) |
| 2. | Press and hold FUNC/SET for two seconds. |
| 3. | You may set the arrow at the bottom of the screen |
|
| to a ascending, or descending limit (but not both). |
|
| To change direction, press SELECT/+ or ST/SP/- |
|
| . |
| 4. | Press FUNC/SET again, then press SELECT/+ or |
|
| ST/SP/- to change the altitude limit. (The alarm will |
|
| be automatically activated once the limits are set). |
| 5. | Alternatively press ST/SP/- if you simply want to |
|
| accept a preset altitude alert setting. (Activated |
|
| [AL] or deactivated [NoAL]). |
12
