TOOLS OF THE TRADE
Listed next are the majority of the tools required to perform an installation.. Having the proper tools will make the installation that much easier.. Some of these tools are necessities; some will just make the job easier..
● Allen Wrenches (2mm and 4mm) | ● | DMM or VOM |
● Electric drill with assorted drill bits | ● | Grommets |
● Heat shrink tubing | ● | Marking pen |
● Phillips and flat blade screw drivers | ● | Nylon tie straps |
● Pliers (standard and needle nose) | ● | Wire crimper |
● RTA (real time analyzer) | ● | Wire cutters |
● Soldering iron and solder | ● | Wire strippers |
●Utility knife
●Wire brush or sandpaper for chassis grounding
●Reference CD with 1 kHz Sine Wave at 0dB level (all bits high)
End Panel Layouts
Input Plate
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 10 | 11 | 12 | 13 |
Figure 1 |
|
|
Figura 1 |
|
|
Abbildung 1 | 14 | 15 |
1.Power LED - when lit indicates that the amplifier is on..
2.RCA Front Inputs - accepts RCA input from the front channels of a source unit..
3.Front Gain Control - continuously adjusts from 250mV to 5V for full front channel output power..
4.Front FULL, HPF Switch - selects either
5.Front Variable Bass Control - Adjust bass gain on front channels from 0dB to +8dB..
6.High Level Input - connect speaker output from factory radio to amplifier, will auto sense signal from radio and turn amplifier on when needed, turn off after 1 minute without signal..
7.2 ch / 4 ch switch - allows all amplifier channels to have input from either 2 channel input (front) or all 4 channel inputs
© 2007 directed | 3 |
