20
AC Breakers O DC Breakers O
Components and Connections

1. With all AC and DC breakers OFF, connect all FXs to the HUB with individual lengths of CAT5 cable.

a) Connect the OutBack MATE after all other components,
including any OutBack Charge Controllers, have been connected
and powered up.
b) Components installed after powering up the system will require
repolling the MATE (please see page 22).
c) With the MATE, a user assigns a status and stacking value to the
FX on each Port. These status and value assignments can be
changed at any time as long as the Master FX is plugged into
HUB Port 01.
• “1-2ph Master” for one and
two-phase systems
• “3ph Master” for a 3-phase
system
• The Master FX is always
considered to be the leg
one phase.
• GTFX and GVFX models
show “Master” not “1-2ph
Master” on the MATE
screen.
POWER HUB
10987654321
2ND
Mate
1st
Mate
• Slave FXs plug into Ports 02 and higher
• OutBack Charge Controllers plug into
any Ports after the last FX is connected.
The FX connected to Port
01 is always programmed
as the Master.
2nd MATE
Port is not
operable
MATE
connects
at 1st MATE
Port
BYPASS OUTPUT INPUT

NOTE: Pay attention to the Port number on the screen! Be sure the FX whose status and stacking value

you’re changing is the one you mean to change.