30
1-2ph Master
With the Port 01 FX as the Master, press the <PORT> soft key to change the remaining Ports and
designate the remaining FXs as Slaves. The MATE screen for Port 02 will look like this:

ADV/FX/STACK---------P02

stack 1-2ph Master
phase

DOWN INC DEC PORT

The MATE is now ready to program the FX plugged
into Port 2 of the HUB.
1-2ph Master is the factory default value for each
FX.

ADV/FX/STACK---------P02

stack 1-2ph Master
phase

DOWN INC DEC PORT

Pressing will keep the MATE’s
attention on Port 2, but will change the stack
phase to Classic Slave screen. Port 02 will then be
assigned as a Classic Slave. You can change the
stacking phase by pressing or
and change to a di erent Port by continuously
pushing .
NOTE: There are no <OK> or <DONE> commands in the stacking menu. Whichever value—Master or
Slave—shows up on the MATE screen will be assigned to the chosen Port (and FX) upon leaving that
screen. It’s important to watch the Port number in the top right corner of each screen to be sure you’ve
assigned it the desired status.
Systems with two to ten FXs call for OutBack
Slave Stacking. Press in the ADV/FX/
STACK screen to change the stack phase from
Classic Slave to OB Slave L1.

ADV/FX/STACK-----------P02

stack Classic Slave
phase

DOWN INC DEC PORT

OutBack (OB) Slave
INC DEC
PORT
INC
INC