Setup Parameters
The following is a listing of the setup parameters.
Configuration Sheet
Setup Parameter | Values | Description |
RESTORE TO MFG no
all
config
prog.1, prog. 2, prog.3, prog 4
The selected values are not set to factory defaults.
The values set in all printer setups are reset to factory default values.
The values set in the configuration setup are reset to factory default values.
The values set in the corresponding program setup are reset to the factory default values.
PROGRAM | progr.1, progr.2, progr.3, | Defines the default Program Setup or Setup couple. The | |||
| progr.4, progr.1/3, | program couples may be selected only if the same | |||
| progr.2/4 | emulation has been selected for the two setups. |
| ||
|
|
| |||
PROGRAM | no, yes | Locks the program setup selection. In case the lock is yes | |||
LOCKED |
| the program setup cannot be changed by pressing the | |||
|
| PROGRAM key. |
|
|
|
|
|
| |||
ERROR BUZZER | 1 beep, no beep | Selects the behavior of the buzzer in case of an error. | |||
|
|
| |||
JOB BUZZER | no beep, 1 beep, | Selects the behavior of the buzzer when a new print job is | |||
| continuous | no beep | 1 beep | ) or a | |
| started: no signal ( | ), one beep ( | |||
|
| continuous signal ( | continuous | ). |
|
|
|
|
| ||
36