Grip | 7/8” Plastic Washers |
Barrel Adjuster | Cable |
GRIP SHIFTERS
Grip Shift™ - Installation
1.Slide front Grip Shift™ assembly over left side of handlebar leaving proper clearance for handlebar grip. If necessary, move the brake lever to accommodate Grip Shift™ and handlebar grip.
2.Rotate assembly until cable exits beneath brake lever with adequate clearance for brake lever movement.
3.Firmly tighten recessed clamp screw. Installation torque should be 20
4.Slide the two 7/8” plastic washers over handlebar. The washers prevent the grip from interfering with Grip Shift™ rotation.
5.Slide handlebar grip over handlebar. Thread the cable inner wire through cable housings and frame, and attach to derailleur. Make sure that the cable is in the V groove at the derailleur attachment bolt. If trimming the cable housing is necessary, be sure to replace the housing end cap.
6.Adjust indexing.
7.Slide rear Grip Shift™ over right side of handlebar and repeat steps 2 - 6.
8.Actuate front and rear brake levers to be certain of proper operation. If Grip Shift™ interferes with brake lever movement, rotate brake lever or Grip Shift™. Check for proper brake lever operation again.
72
