2
About this Guide
This guide contains systematic disassembly instructions for the Packard Bell EasyNote MT. The instructions are illustrated where necessary with images of the part that is being disassembled.
Packard Bell B.V. reserves the right to make changes to the EasyNote MT without notice.
For More Information
For more information about the Packard Bell EasyNote MT, visit Packard Bell‘s support web site at www.packardbell.com. The support web site also has links to additional Packard Bell documentation and detailed product specifications.
Technician Notes
Only technicians authorized by Packard Bell B.V. should attempt to repair this equipment. All troubleshooting and repair procedures are detailed to allow only subassembly/module level repair. Because of the complexity of the individual boards and subassemblies, no one should attempt to make repairs at the component level or to make modifications to any printed wiring board. Improper repairs can create a safety hazard. Any indication of component replacement or printed wiring board modifications may void any warranty or exchange allowances.
Disassembly
When disassembling the system unit, follow these general rules:
Turn OFF the power to the system and all peripherals using the power button.
Unplug the AC adapter and all power and signal cables from the system.
Remove any SD/MMC card, ExpressCard or dummy card from the computer.
Do not disassemble the system into parts that are smaller than those specified in the instructions.
Label all removed connectors; note where the connector goes and in what position it was installed.
The screws for the different components vary in size. During the disassembly process, group the screws with the corresponding components to avoid mismatch when putting back the components.
Reassembly
Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and screws are returned to their proper positions. Check that no tools or any loose parts have been left inside the casing. Check that everything is properly installed and tightened.
Required Tools
To disassemble the computer, you need the following tools:
Wrist grounding strap and conductive mat for preventing electrostatic discharge.
Small Phillips screwdriver.
Small flat screwdriver.
Packard Bell EasyNote MT Disassembly Manual
