Packard Bell manual Memory, Packard Bell EasyNote ST Disassembly Manual

55555 5

2.Lift the cover upwards from the back. There are four tabs holding the cover in place on the front. Raise the cover until you can remove it from the casing (see Fig. 2 on page 4).

3.Pull the plastic tab on the hard disk drives towards the left to disconnect the drives.

Fig. 3 Disconnecting and removing hard disk drive.

4.Take the drives out of the compartment (see Fig.3 on page 5).

5.Remove the four screws (Phillips-head) on the metal brackets to separate them from the hard disk drives.

Note: The drive bays in the compartment are not labelled, so you cannot see which hard disk drive the BIOS considers the first disk.

Memory

To remove the memory installed, first remove the battery (see Battery on page 4) and then perform the following steps:

1.Remove the two screws securing the memory compartment cover.

Fig. 4 Removing memory compartment cover.

2.Lift the cover upwards from the left. There are two tabs holding the cover in place on the right. Raise the cover until you can remove it from the casing (see Fig. 4 on page 5).

Packard Bell EasyNote ST Disassembly Manual