Home Cinema Power Control Software (continued)
5.Windows will recognize your UPS as “New Hardware”.
6.Insert the software disk into the computer’s drive. The instal- lation program should start automatically. If the installation pro- gram does not start automatically, open it manually with the Window’s “Run” command.
7.Follow the
8.Once the software is installed, remove the disk and restart your computer.
For Windows 2000
1.Click on Start, point to Settings then click Control Panel.
2.
3.On the UPS Tab, click Select.
4.In the UPS Selection Dialog Box, under Manufacturers, click None.
5.Exit to the desktop.
6.Shutdown the computer.
7.Turn the UPS off and unplug it.
8.Connect the serial interface cable to the UPS and an open serial port on the back of the computer. (Note: You must use the serial cable that was supplied with the unit).
9.Plug the UPS into an AC outlet, turn the UPS on and start your computer.
10.Windows will recognize your UPS as “New Hardware”.
11.Insert the software disk into the computer’s drive. The installation program should start automatically. If the installation program does not start automatically, open it manually with the Window’s “Run” command.
12.Follow the
13.Once the software has finished installing, remove the disk and restart your computer.
For Windows NT 4.0
1.Click on Start, point to Settings then click Control Panel.
2.
3.. Remove the check mark from the box labeled UPS is installed on.
4.Click OK.
5.Acknowledge the message that the UPS is in an unknown state.
6.Exit to the desktop.
7.Shutdown your computer.
8.Turn the UPS off and unplug it.
9.Connect the serial interface cable to the UPS and an open seri- al port on the back of the computer. (Note: You must use the serial cable that was supplied with the unit).
10.Plug the UPS into an AC outlet, turn the UPS on and then start your computer.
11.Click on Start, point to Settings then click Control Panel.
12.
13.Insert the software disk into the computer’s drive. The installation program should start automatically. If the installation program does not start automatically, open it manually with the Window’s “Run” command.
14.Click Install.
15.Follow the
16.Once the software is installed, remove the disk and restart your computer.
When your computer restarts, the Home Cinema Power Control software will appear on your screen for a few seconds, and then minimize. It will appear as a blue and white battery icon located in the system tray, near the clock.
6 |
| USA & Canada (800) |
