Series 8900SH Control Panel | Operation And Installation Manual |
SECTION 3: ENTRY CODES
The control panel is operated by Entry Codes, which are simple two digit numbers that provide the panel instructions. However, before entering any codes, you should become familiar with the features of the control panel.
The 8900SH has a keypad and a set of 6 display LED’s. A code is entered by simply pressing any of the two digits on the keypad, which will then cause two LED’s on the far left to light up in the order of the keys pressed. You must wait for the Entry Code in the display to begin flashing before entering the desired temperature, value, code, etc.
The (∗) star key on the lower left of the keypad cancels any code you have entered. If the wrong code is entered, simply press the (∗) key and start over.
IF THE PANEL DOES NOT POWER UP, OR THE RED DISPLAY LED’S ARE NOT ON, REFER TO THE WIRING DIAGRAM AND INSTALLATION INSTRUCTIONS. ALSO, REFER TO “SENSOR TROUBLESHOOTING” IN SECTION 5.
Below is a quick reference table showing the codes used to set up the control panel’s basic operation. Do not be concerned that the codes are not listed in numerical order.
YOU MUST ENTER THE CODES IN THE ORDER SHOWN BELOW, THEN CALIBRATE ALL SENSORS CONNECTED TO THE CONTROL PANEL. MORE DETAIL ON EACH CODE IS AVAILABLE IN SECTION 8.
CODE | FUNCTION |
60 | This code starts the sequence for the “60” codes. |
|
|
62 | This code displays the System Mode, which tells us that the boiler system is either ready to |
| heat or is shut off. Press 62 then press 0 (for System Off) or 1 (for System On). |
|
|
63 | This code manually overrides the control panel to control the boilers directly. Press Code 62 |
| first, and enter 0, then press Code 63 and enter the number of the boiler you want to fire. |
|
|
65 | This code allows for the panel to control the system primary pump. After entering code 65, |
| entering 0 shuts the pump off, entering 1 starts the pump, and entering 2 automatically |
| cycles the pump. In the automatic cycle mode, the pump starts and stops along with the |
| boilers according to the system shutdown outdoor temperature chosen in code 21. Please |
| note that the pump starter must be an Automatic Reset type. |
|
|
66 | This code controls the temperature setback feature. When 66 is entered, the display will |
| show 0 or 1. Press 0 to turn it off, or press 1 to turn it automatically on. |
|
|
67 | This code displays the 24 hour (military) clock. Press 67, enter the hour and minutes, and |
| press # to save. |
|
|
68 | This code displays the day of the week and the day of the month. Press 68, enter the day of |
| the week and press #, then enter the day of the month, 01 to 31, and press #. |
|
|
Section 3 | Entry Codes |
