Chapter 3 Recording and playback

3-7 RETAKE function

The RETAKE function ensures continuity with the previous cut on the tape when shooting is resumed.

It is set by opening the <REC FUNCTION> screen from the SYSTEM SETTING page and selecting ON as the setting for the RETAKE MODE item by performing menu operations.

The RETAKE MODE item settings are described below.

ON: The retake operation is performed when the RET button on the lens is pressed while the MODE CHECK button is held down.

OFF: The RETAKE function does not operate.

If, when the rec-pause mode is established upon completion of the recording or the stop mode is established afterwards, the RET button on the lens is pressed while the MODE CHECK button is held down, the tape will be rewound to the approximate start point (a position advanced by 10 or so frames from the recording start) of the final image that was last recorded, and the rec-pause mode will be established.

If there is some leeway in the shooting time and a “NG” condition has been clearly identified, recording can be started from this point, and the cut in the NG area will be deleted.

This function is particularly useful for cutting the amount of time taken for copying onto work tapes and other such economical operations.

Direction of tape travel

Cut 1

Cut 2

Cut 3

Approx. 10 frames

Cut 1

Cut 2

Cut 4

Cut 3

When the RETAKE function is to be exited

There are two ways to do this.

1)Set the unit’s POWER switch to OFF.

2)Perform a menu operation and select OFF as the RETAKE MODE item setting.

3-8 Rec-review function

When recording is temporarily stopped and the lens RET button is pressed, the last two seconds of the tape are automatically rewound, and the playback pictures on this part of the tape appear on the viewfinder screen. This makes it possible to check whether recording was performed properly. 3 After the two seconds of the tape have been played back, the

unit is again set to the recording start standby mode.

If the RET button is held down, a maximum of 10 seconds of the tape is rewound and played back.

The RET button function can be allocated by opening the <USER SW> screen from the OPERATION page and selecting settings for the USER MAIN SW, USER1 SW and USER2 SW items by performing menu operations.

<Note>

≥The rec-review function cannot be used unless recording lasts for one or more seconds.

≥If the OUTPUT SEL switch on the side panel is at the VTR position during the rec-review operation, the rec-review images are output not only to the viewfinder but to the video output connectors (VIDEO OUT connector and MON OUT connector) as well. Bear in mind that if back-up images are being recorded by a backup VTR that has been connected, these rec-review images will end up being recorded.

Direction of tape travel

 

 

 

Rec-pause

 

 

 

 

 

 

 

 

Recording section

 

No recorded or already recorded section

 

 

 

 

 

 

 

 

2 to 10 sec.

 

 

 

Rec-review operation

Rec-pause

 

 

 

 

 

 

 

 

 

 

 

Playback of recorded section

 

 

 

 

 

 

 

 

 

3-9 Normal playback and playback at different speeds

Black-and-white playback images can be viewed in the viewfinder by pressing the PLAY button. At the same time, color playback images can be viewed if a color video monitor is connected to the unit’s VIDEO OUT connector and MON OUT connector.

≥In order to view these images, the OUTPUT SEL switch on the side panel must be set to the VTR position.

In addition, when the FF and REW buttons are used, the images can be played back at different speeds by establishing the cue mode (PLAY + FF), review mode (PLAY + REW), high-speed fast forward playback mode (FF) or high-speed rewind playback mode (REW).

25