12 When the JOG dial button is message appears.
DETECT?
YES
# NO
CORRECT
# DETECTION(V.SAW)
< WHITE SHADING >
Repeat step 7.
<Notes>
8
7
Chapter 5 Preparation

Set the lens aperture control to manual, and adjust it so

13 Turn the JOG dial button to move the arrow (cursor) to

 

that the zebra pattern covers the whole screen. Check

YES, and press the JOG dial button.

 

that the lens aperture is between F4 and F11.

ACTIVE now appears on the screen. This indicates that

 

 

the white shading is now being automatically

 

≥The zebra pattern will not cover the whole screen if

compensated. Upon completion of the adjustments, W-

 

SHD OK is displayed.

 

there is any unevenness in the lighting. In this case,

 

 

 

make adjustments to the position of the lighting, etc.

<Note>

 

≥Make adjustments to the position of the lighting, etc.

Depending on the KNEE settings, “LEVEL OVER” may

 

also when the lens aperture is not between F4 and F11.

appear on the screen and white shading compensation

 

≥Be absolutely sure to leave the electronic shutter at

may not be possible. If this is the case, either stop down

 

OFF.

the lens or set the AUTO KNEE OUTPUT switch to OFF,

 

 

then perform a menu operation to open the

 

 

5

1 Set the WHITE BAL selector switch to “A” or “B,” and

<KNEE/LEVEL> screen from the PAINT screen, select

“OFF” as the MANUAL KNEE item setting, and repeat

use the AUTO W/B BAL switch to adjust the white

steps 4 through 9. After “W-SHD OK” has appeared on

 

balance automatically (AWB).

 

the display, select “ON” again as the MANUAL KNEE

 

2 Use the AUTO W/B BAL switch to adjust the black

 

item setting.

 

balance automatically (ABB).

 

 

 

3 Again, use the AUTO W/B BAL switch to adjust the

14 If the extender is attached to the lens, turn on the

 

white balance automatically (AWB).

 

 

extender function or, alternatively, if the ratio converter is

 

9

attached, turn on the ratio converter function. In either

 

case, repeat steps 7 through 13.

 

10 Perform a menu operation to open the <WHITE

The compensation values for 3 patterns—namely, when

 

the lens extender is used, when the ratio converter is

 

used and when neither the lens extender nor ratio

 

SHADING> screen from the MAINTENANCE page.

converter is used—are stored in the unit as the data of

one lens file.

11 Turn the JOG dial button to move the arrow (cursor) to

the DETECTION (V.SAW) item, and press the JOG dial

This now completes the white shading adjustments.

button to execute white shading compensation.

The adjustment values are now stored in the non-volatile

 

 

memory so that even when the unit’s power is turned off,

:ON

there will be no further need to perform the white shading

adjustment.

 

pressed, the following

63