How to Use the On Screen Menu

Six types of information are displayed on the screen: the operating status display, picture adjusting knob status, sharpness display, function display, DC power supply voltage display, battery level display and menu display.

Operating status display

1 2

7

YPBPR 1080/60I

 

P-P

 

6

DC14.0V

50%

5 4

3

1.The selected input line (→ page 7, 2 )

•YPBPR, VF-YPBPR/VF-VIDEO, VIDEO, SDI

2.Signal format

•The display status can be set in “STATUS DISPLAY” in the “SYSTEM CONFIG” menu (→ page 21).

•If “UNSUPPORT SIGNAL” is displayed, then either the current input signal is not supported or the “INPUT SELECT” menu setting needs to be changed.

•When “NO SIGNAL” is displayed, there is no input signal.

3.Battery level display

•When an Anton/Bauer type digital battery is used, battery level is displayed using a block count () and percentage.

4.Various displays (PIXEL TO PIXEL mode)

•Displayed when the picture display is PIXEL TO PIXEL.

5.Various displays (warning of improper operation status for the camera settings)

•Displayed when there is an improper operation status relative to the camera settings.

6.DC power supply voltage display

•DC power supply voltage is displayed.

7.Various displays (lock setting)

•Displayed when front operations are locked (→ page 30).

<Note>

“UNSUPPORT SIGNAL” and “NO SIGNAL” may not be displayed correctly.

Picture adjusting knob status

[PHASE] 32

Picture adjusting knob (→ page 7, 4 )

• This knob can be rotated and pushed.

• The status display appears when the knob is pushed. The display disappears when the knob is pushed again, or if the knob is not operated for 10 seconds.

• The settings can be adjusted while this display is shown, but the settings cannot be adjusted after the display disappears.

Status display:

PEAKING or PHASE

CHROMA or FOCUS-IN-RED

BRIGHT

CONTRAST or BACKLIGHT

12