Supplying the power

An Anton/Bauer or V-mount type of battery pack or an external DC power supply can be used to power this monitor.

Using the Anton/Bauer type battery pack

1.Install the Anton/Bauer type of battery pack.

Battery pack

2.Insert the battery pack and slide it in the direction of the arrow.

Release lever

<Reference>

To remove the battery pack, slide it in the opposite direction to the one in which it was attached while keeping the release lever on the battery holder pulled down all the way.

Using a V-mount type battery pack

CAUTION:

These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

1.Remove the battery holder.

Battery holder

2.Install the accessory battery mount terminal block.

Battery mount terminal block

3.Fix the V-mount type battery holder with four screws (length 8 mm (5/16 inch)) supplied with the holder, and then fasten the two screws on the terminal section.

This connector is not used.

V-mount type battery holder

9