Error/Warning Displays

If for any reason an error occurs in the unit, the user is alerted of error or warning with the following displays.

Error/Warning

Display

Solution

Inverter error

All the lamps on the side of

Switch the power supply OFF once, then switch it

 

picture adjusting knobs flash at

back ON again. If an error is still displayed, contact

 

1-second intervals.

the vendor where you purchased the unit.

Warning of improper

is displayed.

Check the setting values of the camera.

operation status for the

 

 

camera settings

 

 

Battery level warning

The voltage display flashes.

Replace with a fully charged battery.

Battery level error

“END BATTERY” is displayed for

Replace with a fully charged battery.

 

approximately 3 seconds before

 

 

the power supply switches OFF.

 

Maintenance

•To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth.

If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then wrung-out to clean the surfaces, then use a dry cloth to finish. Water or similar substances getting inside the monitor can cause a malfunction.

•Never use thinner or benzene to clean this unit.

Doing so would cause the surface of the monitor to become discolored, and cause paint to peel.

•Do not spray cleansers directly onto the monitor.

Water or similar substances getting inside the monitor can cause a malfunction.

Specifications

GENERAL

Power supply: DC 12 V (11.0 V to 17.0 V)

Input current: 1.5 A

 

indicates safety information.

 

Dimensions (W × H × D):

218 mm × 166 mm × 64.7 mm

 

 

(8-9/16 inches × 6-9/16 inches × 2-9/16 inches)

Weight:

1.5 kg (3.3 lb)

Operating temperature:

0 °C to 40 °C (32 °F to 104 °F)

Operating humidity:

10 % to 85 % (no condensation)

Storage temperature:

–20 °C to +60 °C (–4 °F to +140 °F)

 

Panel

 

 

 

Size:

7.9-inch V (Effective display area)

Aspect ratio:

Panel: 16:9 (Effective display area)

Number of pixels:

Panel: 800 × 450 (Effective display area)

Display colors:

Approx. 16.77 million colors

Angle of view:

Top-bottom direction: 110 ° Left-right direction: 120 °

 

Input connectors

 

 

 

VIDEO:

1 line, BNC × 1 (Shared with the analog component Y input terminal)

Analog component (YPBPR):

1 line, BNC × 3

 

 

(Of these, the Y input terminal is shared with the VIDEO input terminal)

SDI:

1 line, BNC × 1 (Optional)

VF:

D-sub, 15 pins × 1

GPI:

D-sub, 9 pins × 1

RS-232C:

D-sub, 9 pins × 1

36