37
Fingerprint Reader
2Set the High Security Level.
ASelect [Fingerprint Security], and press (Enter).
BSelect [Security mode], and select [High].
• Default setting: Simple
CPress
Esc
to close the sub-menu.
DPress
F10
, select [Yes], and press (Enter) to exit the Setup Utility.
NOTE
zIn the [High] security mode, you have to enter the Supervisor or User Password even after fingerprint authentica tion.
In the [Simple] security mode, you do not have to enter the Supervisor or User password after fingerprint authentica-
tion.
Backup
The file described below is necessary for recovering the Fingerprint authenti cation data. Back up this file periodically in a safe
location such as removable disk to avoid data loss resulting from some acci dents. We recommend you to store the file in a
removable disk or network drive because the benefit of Fingerprint authentica tion security can be reduced if you keep the file
in the internal hard disk drive.
The backup password described below is necessary for bypassing the Fingerprint authentica tion. We recommend you to set
the
backup password using the [User Enrollment] wizard. If you do not define the back up password, you may lose your data in
case of authentication hardware failure.
zFile used by each user
• Backup user passport data
(Default name: <UserAccount>.vtp)
You need this file when you replace the embedded fingerprint chip, or the hard disk drive, or when reinstalling Windows.
This file contains the fingerprints, encryption keys, and logon authentication data.
NOTE
zHow to Backup:
Select [Export] in [Import or Export User Data] to save the user data.
• Click [start] - [All P rograms] - [Protector Suite QL] - [Control Center] - [Fingerprints].
For further information, refer to the software’s online manual (Î page 33).
Useful Information