Panasonic C7401U, CQ-C8401U, C7301U, C8301U operating instructions Preparation, Setting

Preparation

The demonstration message appears for first use.

	1 Set your car's ignition switch to the ACC	SRC	CQ-C8401U
	or On position.
On	The demonstration screen appears.
FirstTime Power (DEMONSTRATION)	3 Press [SRC] (PWR: Power).	(PWR: Power) for 4 sec. or more after turning off the
	2 Press [DISP] (Display).
	The demonstration screen is cancelled, and no more	Note: If you would like to turn on the power and make
	appears.
		the demonstration message appear, hold down [SRC]
		power in other than the XM mode.

	Preparation Before Initial Use		Warning
	Pull the insulation film out		Keep batteries and insulation film out of reach of
			infants. If an infant ingests a battery, please seek
	from the backside of
			immediate medical attention.
	remote control gently.
			Cautions
	Insulation film		¡Remove and dispose of an old battery immediately.
Preparation			¡Do not disassemble, heat or short a battery. Do not
	q Stick your thumbnail into
	Battery Replacement		throw a battery into a fire or water.
	q Remove the battery holder	Tough pointed object	¡Follow local regulations when disposing of a battery.
			¡Improper use of a battery may cause overheating, an
	with the remote control unit
			explosion or ignition, resulting in injury or a fire.
	placed on a flat surface.
Control	the groove, and push the		Note: Battery Information:
			Battery Type: Panasonic lithium battery (CR2025)
	holder in the direction of
			(Included in the remote control)
	the arrow, and at the
			Battery Life: Approximately 6 months under normal use
	same time.
		w	(at room temperature)
Remote	w Pull it out in the direction
		q
	of the arrow using a
	tough pointed object.	Back side
	w Put a battery in the case	2
	with (+) side facing up.
	e Put the case back.

3

	The following functions are activated when the Security
	Function is ON. (a page 35)
SecurityFunction	¡ The security indicator lights up when removing the
	face plate.
	Setting
	Security Indicator
	You may need to set the following depending on the
	devices to be connected.
	Using Subwoofer
	¡ Subwoofer level adjustment (a page 34)
Settings	¡ Subwoofer low pass filter (a page 34)
	¡ To connect the XM receiver (XMD1000), it is required
	Connecting XM tuner
	¡ Connect the optional XM receiver (XMD1000).
Other	to use an optional extension cord (XMDPAN100) that is
	produced by XM exclusively for Panasonic products.
	Getting Started
	It is required to sign up to become an XM Satellite Radio
	subscriber. After checking your XM Satellite Radio ID,
	sign up on the XM’s website or by calling them.

	Note: Adjust the clock when “ADJUST” appears on the
	display.
adjustment	1 Press [MENU] to display the menu
	display.
	2 DISPLAY menu.
	For using the remote control, hold down [SEL]
	(MENU) for 2 sec. or more.
Clock	Press []] or [[] to display the
	3 Press [{] to select “CLOCK ADJ”.
	4 Press [BAND] (SET) to confirm the
	display.

¡The alarm sounds and the message appears on the

screen to warn you to remove the face plate at ACC
off.	English

1Check of XM Satellite Radio ID	Preparation
¡ Write down the ID indicated on the lower right of your
XM receiver (XMD1000).
¡ Radio ID also can be found by turning your XM Radio
to channel 0. (a page 28.)
2 Activate the XM Satellite Radio
Select either of the below to sign up.

¡Web site: http://www.xmradio.com/activation

¡Phone number: 1-800-XM-RADIO (1-800-967-2436) Note: Refer to the operating instructions for the XM receiver for details.

5 Adjust the setting value.

[[]: Adjusting minutes

[]]: Adjusting hours

[}]: Forward

[{]: Backward

6 Press [BAND] (SET) to confirm the adjustment.

7 Press [MENU].

For using the remote control, hold down [SEL] (MENU) for 2 sec. or more.

12 CQ-C8401U/C8301U/C7401U/C7301U CQ-C8401U/C8301U/C7401U/C7301U 13