Panasonic CQ-D5501U Wiring, CY-VH9300U Option, Hand brake, Parking Brake Lead

E	Wiring
G
N
L
I
S
	Before Wiring
H
49
	¡ Exclusively operated with 12 V battery with negative (–) ground.
	¡ Connect the power lead (red) very last.
	¡ Connect the battery lead (yellow) to the positive (+) terminal of the battery or fuse block terminal (BAT).
	¡ Strip about 5 mm {1/4 ”} of the lead ends for connection.
	¡ Apply insulating tape to bare leads.
	¡ Secure loosened leads.
	Connecting the Parking Brake Connection Lead

Caution

¡For safety, be sure to ask your nearest professional installer to do this connection.

Connection with the CD Changer and the Overhead Monitor (CY-VH9300U)

Connection with CD changer and the overhead monitor (option, CX-DP880, CY-VH9300U).

Note:

¡Refer to the operating instructions for the connected devices, in addition.

	VIDEO-	VIDEO-OUT (Yellow)
			(L)(White)
	OUT
		CH/AUX-IN	RCA Cord	CX-DP880 (Option)
Antenna		CH/AUX-IN
			(R)(Red)	CD Changer Unit
			DIN Cord
				Extension Cord

E

N

G

L

I

S

H

50

Hand brake Foot brake

Parking brake switch

The parking brake switch position varies with the car model.

For details on the exact location of the parking brake switch in your car, contact your dealer.

Parking Brake Lead (Blue/yellow stripe)

When the parking brake lever is engaged, the unit is grounded by the

Brake light

chassis.Battery

PARKING BRAKE + –

Clip Connector u

Car chassis

qAttach a Clip Connector u to the end of the parking brake connection lead.

Parking Brake Lead

(Blue/yellow stripe)

wThe Clip Connector u is connected to the power source side lead of the park- ing brake.

Power source side lead

Antenna Cable			(DIN/BATT/RCA/GND)
			Fuse*
CQ-D5501U			Power Connector	Ground Lead
				To a clean, bare metallic
DVD Player/Receiver				part of the car chassis.
			PARKING BRAKE	Battery Lead
*Fuse (15 A) Refer fuse replacement to your near-			Parking Brake Lead
			(Blue/yellow stripe)	To the car battery, contin-
est authorized Panasonic Servicenter. Do not try fuse			Be sure to wire the parking brake	uous + 12 V DC
replacement by yourself.			for safety and preventing accident.
	3		Motor Antenna Relay Control Lead
1			(Blue)
					RCA Cord
		2
					VIDEO-IN
			External Amplifier Control Power Lead
					(Yellow)
		(Black)	(Blue/white stripe)
Ground Lead
					Not used
To a clean, bare metallic part of the car
chassis.		(Red)	– IN
ACC			VTR1
Power Lead
			VIDEO-CONT
To ACC power, + 12 V DC
		(Yellow)	Video Control Lead
			CONT

When connecting this unit to the rear monitor (overhead/headrest):

¡The parking brake lead and grand lead should be connected to the same terminal.

Speaker Connection

Battery Lead		BATTERY 15A		(Green/yellow stripe)
					VIDEO
To the car battery, continuous + 12 V DC
Green/black stripe	REAR SP		FRONT SP

Connect as follows

¡Use ungrounded speakers only.

Allowable input: 50 W or more

Impedance: 4 – 8 Ω

¡Distance between speaker and amplifier: 30 cm {12”} or more

¡Do not use a 3-wire type speaker system having a common earth lead.

Caution

¡Do not connect more than one speaker to one set of speaker leads. (except for connecting to a tweeter)

	Violet/black	White/black	Gray/black
	stripe	stripe	stripe
-	+ Green -	+ Violet -	+ White -	+ Gray	CY-VH9300U (Option)
					Over Head Monitor
Left	Right		Left	Right
	Rear Speakers		Front Speakers
	CJ-DA6920U		CJ-DA1600U

50

51

CQ-D5501U CQ-D5501U