HIGH POWER
This function acts to raise the power but keeps the AC system in the same operating mode.
This function is set with the HIGH POWER button on the remote controller.
(It can be set regardless of the temperature and fan speed settings.)
HIGH POWER operation from remote controller
The unit operates at maximum output for 30 minutes, regardless of the desired temperature.
The fan speed is 1 step above "High."
Frequency |
MAX |
NIGHT SETBACK
When NIGHT SETBACK operation is set, the temperature and fan speed settings will be adjusted automatically to allow comfortable sleep.
When NIGHT SETBACK operation is set, "
mark" appears on the remote controller. The main unit display lamp also becomes dimmer.
COOL and DRY modes
When the night setback mode is selected, the air conditioner automatically raises the temperature setting 2°F(1°C) when 30 minutes have passed after the selection was made, and then another 2°F(1°C) after another 30 minutes have passed, regardless of the indoor temperature when night setback was selected. This enables you to save energy without sacrificing comfort. This function is convenient when gentle cooling is needed.
0 | Time |
30 min. 5 min.
Start End
NOTE
Setting temperature
Press the NIGHT SETBACK button
2°F(1°C) |
|
|
2°F(1°C) |
|
|
30 min. | 30 min. | Time |
|
|
When HIGH POWER operation ends, the unit operates at low Hz for 5 minutes, regardless of the thermostat OFF conditions.
When in DRY mode, operation is in the cooling zone.
Lamp colors
OPERATION lamp |
HEAT mode
When the night setback mode is selected, the air conditioner automatically lowers the temperature setting 4°F(2°C) when 30 minutes have passed after the selection was made, and then another 4°F(2°C) after another 30 minutes have passed, regardless of the indoor temperature when night setback was selected. This enables you to save energy without sacrificing comfort. This function is convenient when gentle heating is needed.
HEAT operation | Red |
DRY operation | Orange |
COOL operation | Green |
FAN operation | Green |
DEFROSTING operation | Red and Orange |
| alternately |
OPERATION lamp | Green |
TIMER lamp | Green |
HIGH POWER lamp | Green |
Timer backup
Operation stops if there are no operator controls for 25 hours or longer after unit operation switched from OFF to ON by use of ON timer operation.
Setting temperature
Press the NIGHT SETBACK button
| 4°F(2°C) |
|
|
| 4°F(2°C) |
30 min. | 30 min. | Time |
|
|
48
