Panasonic DMC-TZ8 Using the DC coupler optional instead of battery, Open DC coupler cover

Using the DC coupler (optional) instead of battery

By using the AC adaptor (optional) and DC coupler (optional), you can record and play back without worrying about the remaining battery charge.

The optional DC coupler can only be used with the designated Panasonic AC adaptor.

Insert DC coupler instead of battery (previous page)

DC IN	DC coupler
terminal
DC coupler
cover
AC adaptor	Align the marks to
	connect

Open DC coupler cover

•If difficult to open, with the card/ battery door open, press the coupler cover from the inside to open it.

Plug AC adaptor into power outlet

Connect AC adaptor to DC IN terminal of DC coupler

●Always use a genuine Panasonic AC adaptor (optional).

●Use the AC adaptor and DC coupler specifically for this camera. Using other adaptors or couplers could cause camera failure.

●It may not be possible to install camera on a tripod or unipod when the DC coupler is connected, depending on the type of tripod or unipod.

●The camera cannot be stood up when the AC adaptor is connected. If you are leaving the camera on a surface as you work, it is recommended to set it on a soft cloth.

●When the AC adaptor is connected, always remove the AC adaptor when opening the card/battery door.

●Remove the AC adaptor and DC coupler when not in use and close the coupler cover. ●Also read the AC adaptor and DC coupler operating instructions.

VQT2R48 15