Panasonic DMR-E20 warranty Plug-in Auto Tuning, º Channel plan, Í/I,Power ,,Ch Enter

Í/I,POWER ,,CH

ENTER

Plug-in Auto Tuning

Note
³Plug-in Auto Tuning does not work if you turn the unit on by press-
ing [<, OPEN/CLOSE] or [1, PLAY].
³After the unit sets the clock automatically, it then adjusts the clock
everyday.
³If the unit sets the time incorrectly, use “Time Zone Adjust” to cor-
rect it (➡ page 89).
³You can give the stations captions (➡ page 92).
³If you connect the unit through a cable TV box or DSS receiver
(➡ page 76), tune to your local PBS station before starting auto		started
³If there is no local PBS channel in your area then Auto Clock Set-
clock setting. Use manual clock setting (➡ page 88) if this does not
work.		Getting
ting may not work correctly. In this case the time must be set man-
ually (➡ page 88).
º Channel plan
The unit automatically determines the type of transmission (airwave
or cable) and puts them into channels as follows.
³TV Mode
Band	Stations received by
	airwaves
VHF	2–13
UHF	14–69
³CATV Mode
Band	Stations received by cable
VHF	2–13
CATV LOW BAND	95–99
CATV MID/SUPER BANDS	14–36
CATV HYPER BAND	37–65
ULTRA BAND	66–94
	100–125
SPECIAL CATV CHANNEL	1

ºTo start Plug-in Auto Tuning again (after moving house, for example)

Main unit only

While the unit is on and stopped

1.Press and hold [X, CH] and [W, CH] for about five seconds. ³The unit turns off.

2.Press [ê/I, POWER] to turn the unit on.

The screen shown in step 1 on page 16 appears. Press [ENTER] to start Plug-in Auto Tuning.

³Antenna system, channel caption, and VCR Plusi guide channel settings all revert to the default values when you perform the above procedure. Timer recording settings are also cleared.

17

RQT6035