Panasonic EW3153W guide

Inserting the Batteries into the Wireless Display

*Always use alkaline batteries. (2 AA-size LR6 alkaline batteries)

•When replacing batteries, always use 2 fresh alkaline batteries of the same type from the same manufacturer, and replace them simultaneously.

1.Turn the wireless display over and remove

the battery cover by sliding it in the direction of the arrow while pressing lightly on the mark.

2. Check the polarities of the batteries and install them correctly.

3.Replace the battery cover and slide it closed.

Replace batteries when:

•The mark shown at left appears during use.

In this case, press the On/Off and the Start button on the

main unit to interrupt the measurement.

If both batteries for the main unit and the wireless display must be replaced at the same time, (main unit) and (wireless display) are alternately displayed.

13English

Image 14

Panasonic EW3153W manual Inserting the Batteries into the Wireless Display

Contents

Instructions English Table of Contents Introduction Basics of Blood Pressure Important Instructions Before Use English Precautions to Ensure Safe, Reliable Operation English Blood Pressure Categories Systolic Blood Pressure SBP Preparations Prior to Taking Measurements Parts Identification Battery cover for main unitIR transmitter on both sides Connector Arm support Main unit View from Top Wireless display View from Bottom AM/PM comparison button When Using the Main Unit with Batteries Turn the main unit over Inserting the Batteries into the Wireless Display Adjust the date Setting the time and dateAdjust the month Adjust the hour Put the main unit on a table in front of you AdviceTaking a Reading Posture to obtain accurate measurements Sit quietly and relax while taking measurements Do not take measurements Positions of the main unit and the wireless display Arm is applied Remove your arm from the main unit MeasurementPress the On/Off and Start button on the main unit Movement detection function Irregular pulse function Alarm function signals high blood pressure When an Error Occurs During Measurement If the pressure cuff comes off Storing blood pressure readings Press the Memory/Recall button Memory storage is completed Calling up readings from memory Press the Memory/Recall button Deleting all data stored in memory Press the Adjust button 2 to switch off the unit Press the button After Use Specifications Mark does not light when an arm is moved Is still higher than usual When should I measure my blood pressure?Mark was displayed, I retried the measurement Care and Maintenance Symptom Possible cause TroubleshootingDisplay Status before error Cause and solution Press the ring portion on the outside One Panasonic Way 1H-1 Secaucus, NJ No.1 EN, SP