Wireless display View from Bottom | Panasonic EW3153W specification

2. Insert the AC adapter plug into the connector on either side of the main unit.

3. Plug the power cord fully into the AC outlet.

1. Connect the power cord to the AC adaptor.

AC 120 V

Be sure to use only the exclusive AC adapter (included).

Do not use the power cord with any product other than this AC adaptor (EW31555).

Use of other AC adapters could cause damage to the unit or physical harm to the user.

*Specifications of the product or parts may be changed without prior notice.

When Using the Main Unit with the AC Adapter

Parts Identification (continued)

Wireless display

View from Bottom

Blood pressure indicator

Memory/Recall button

1

6

Display

User selection button

2

7

Set button

Battery cover for wireless display

3

8

Adjust button (Display off)

IR receiver

4

9

5AM/PM comparison button

11English

Image 12

Panasonic EW3153W manual Wireless display View from Bottom, AM/PM comparison button

Contents

Instructions English Table of Contents Introduction Basics of Blood Pressure Important Instructions Before Use English Precautions to Ensure Safe, Reliable Operation English Blood Pressure Categories Systolic Blood Pressure SBP Preparations Prior to Taking Measurements Battery cover for main unit IR transmitter on both sides Connector Arm supportParts Identification Main unit View from Top Wireless display View from Bottom AM/PM comparison button When Using the Main Unit with Batteries Turn the main unit over Inserting the Batteries into the Wireless Display Setting the time and date Adjust the monthAdjust the date Adjust the hour Advice Taking a ReadingPut the main unit on a table in front of you Posture to obtain accurate measurements Sit quietly and relax while taking measurements Do not take measurements Positions of the main unit and the wireless display Arm is applied Measurement Press the On/Off and Start button on the main unitRemove your arm from the main unit Movement detection function Irregular pulse function Alarm function signals high blood pressure When an Error Occurs During Measurement If the pressure cuff comes off Storing blood pressure readings Press the Memory/Recall button Memory storage is completed Calling up readings from memory Press the Memory/Recall button Deleting all data stored in memory Press the Adjust button 2 to switch off the unit Press the button After Use Specifications Mark does not light when an arm is moved When should I measure my blood pressure? Mark was displayed, I retried the measurementIs still higher than usual Care and Maintenance Troubleshooting Display Status before error Cause and solutionSymptom Possible cause Press the ring portion on the outside One Panasonic Way 1H-1 Secaucus, NJ No.1 EN, SP