Taking a Reading (continued)
Measurement
The entire display will light for approx.
1 second.
The pressure cuff will be tightened automatically.
The heart mark 
will blink when pulse is detected during pressurization.
1Press the On/Off and Start button on the main unit.
(1)After the entire display on the wireless display has been lit, the pressure cuff will be tightened automatically.
(2)Pressurization will be performed automatically and measurements will be taken.
*It may take about 1 second for the wireless display to turn on after pressing the On/Off and the Start button. This is not abnormal.
*The angle of the main unit may change slightly while pressurizing. This will not affect accuracy.
2When measurement has been completed, the blood pressure and pulse values will be displayed.
The cuff will loosen after the measurement result has been shown for about 5 seconds.
• The blood pressure indication ( mark) will flash for 6 seconds then stay lit. If the measurement is high, it will also flash for 6 seconds to indicate high blood pressure. (See page 22.)
• The mark will light. (For storing measurement values, see page 24.)
•The pulse rate value is the beats per minute calculated based on the pulse rate during measurement.
•The
mark is displayed when pulse rate could not be measured.
3Remove your arm from the main unit.
4To switch off the blood pressure monitor, press the On/Off and Start button on the main unit.
•If you forget to switch it off, the blood pressure monitor will switch off automatically after approximately 2 minutes.
•When the Adjust button “2” on the wireless display is pressed, indications disappears but the power of the main unit is still on for about 2 minutes.
