4. Press the Off/On Start button.
• The display will be lit up for approx. 2 seconds.
• The cuff will begin to inflate automatically.
As measurements are being taken during pressurization, operating sounds and the rate of pressurization may change. This is perfectly normal.
• The pulse detection mark will be displayed graphically during pressurization when the pulse is detected.
Pulse detection mark
5. When measurements have been completed, blood pressure and pulse rate are displayed.
• Pressure will automatically be released from the pressure cuff.
• If your blood pressure is considered to be in the hypertensive range, then the readings on the display will flash for approx. 6 seconds. (Please see page 21.)
• Measurement results are also displayed as graph. (Please see page 21.)
•The 
mark will be flash.
(Please pages 26 and 27 for details regarding how to record readings.)
•The pulse is estimated over the period of a minute based on the pulse rate recorded when measurements were being taken.
6. Press the Off/On Start button to turn off the unit.
• If you forget to switch the device off, it will do so automatically after approx. 5 minutes.
