Troubleshooting
Display | Status before error | Cause and solution | ||
is | The indication disappears in | Batteries are exhausted. | ||
the middle of the operation. | ||||
displayed. | (Please see page 9.) | |||
(the | mark is displayed.) | |||
|
| |||
| Pressurization to more than | Were measurements taken | ||
| 280 mmHg was performed. | according to the proper | ||
| (Cuff pressurizes several | procedure and in the | ||
| times.) |
| correct posture? | |
| Pressure decreased suddenly. | (Please see pages | ||
| Is the cuff wrapped | |||
|
| |||
is | The pulse detection mark was | |||
displayed. | displayed only a few times or | properly? | ||
| not at all. |
| (Please see pages 12 and | |
|
|
| 13.) | |
| Cuff does not inflate. | |||
|
| |||
|
|
| Has the unit detected | |
| Your hand or wrist moved. | movement? | ||
|
|
| (Please see page 24.) | |
is |
|
| Take it to the store where it | |
Failure of the main unit | was purchased for testing | |||
displayed. | ||||
|
| and repairs. | ||
|
|
|
Symptom | Possible cause |
The SYS or DIA is | • The pressure cuff is positioned too low. |
high. | (Please see pages 14 and 15.) |
| • The pressure cuff is not wrapped around the |
| wrist properly. |
| (Please see pages 12 and 13.) |
| • The person is moving or talking when the |
| measurement is being carried out. |
| (Please see pages 14 and 15.) |
The SYS or DIA is | • The position of the pressure cuff is too high. |
low. | (Please see pages 14 and 15.) |
| • The person is moving or talking when the |
| measurement is being carried out. |
| (Please see pages 14 and 15.) |