Panasonic EY4541 Control Panel, Cutting at the same width, Cutting circles, LED light

Cutting at the same width

1.Place the base onto the workpiece so that the edge of the rip fence and workpiece are put together.

2.Without letting the blade touch the workpiece, turn on the power switch.

3.Face the rip fence firmly to the workpiece to cut parallel line.

Cutting circles

1.If cutting away a section, make a drill hole on workpiece to let the jigsaw blade pass through.

2.Align the pin hole of the rip fence with the center of the circle, and then use a nail or screw to hold the object in place.

Control Panel

(1)

(3)

(2)

(1) LED light

Before the use of LED light, always pull the power switch once.

Press the LED light button.

The light illuminates with very low current, and it does not ad- versely affect the performance of the driver during use or its battery capacity.

CAUTION:

•The built-in LED light is designed to illuminate the small work area tem- porarily.

•Do not use it as a substitute for a regular flashlight, since it does not have enough brightness.

•LED light turns off when the tool has not been used for 5 minutes.

Caution : DO NOT STARE INTO BEAM. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation ex- posure.

3.Without touching the workpiece, turn on the power switch.

4.Cut along the marked line.

-12 -