Adjusting the base
1.Use the hex wrench to loosen the base fixing screw.
2.Move the base along the base ad- justment hole to set its position. (See the diagram at right.)
•The base can be adjusted to between 0° and 45° sideways and the for- ward/back position can also be ad- justed. If tilting the base sideways, remove the dust cover first.
•Refer to the bevel index to determine the angle.
•Rip fence fixing screw should be lo- cated on the opposite side tool is bev- eled.
3.Use the hex wrench to tighten the base fixing screw.
Position of base and purpose of use
Base adjustment | Purpose of use | |
hole position | ||
|
Normal
Cutting at an angle between 0° and 45°
Cutting at an angle of 45°
Cutting close to the end of a wall
3 | 2 |
| 1 |
| 0 |
NOTE:
This is only a rough guide. The ac- tual angle of the cut will be affected by factors such as the way the tool is held against the surface.
- 8 -
