Cutting along marked lines
1.Place the object to be cut onto the base, and align the blade with the marked line.
•Do not touch the blade against the object to be cut before pulling the power switch.
2.Pull the power switch, wait until the speed has stabilized, and then place the base against the object to be cut and cut along the marked lines.
•When cutting complex shapes such as shapes with many small curves, reduce the cutting speed and the turning speed.
Plunge cutting
1.Make a drill hole in the section to be plunge cut in order to let the blade pass through.
2.Insert the blade into a hole without touching the workpiece, and then turn on the power switch.
3. Cut along the marked line.
Using a rip fence (EY9X011E) (Available as an accessory, not included)
A rip fence can be used for cutting parallel lines and for cutting circles and arcs.
Installing the rip fence
1.Loosen the rip fence fixing screw.
2.Pass the rip fence through the mount.
3.Adjust the cutting position and then tighten the fixing screw.
- 13 -
