Cutting at the same width
1. Place the base onto the workpiece
so that the edge of the rip fence and
workpiece are put together.
2. Without letting the blade touch the
workpiece, turn on the power switch.
3. Face the rip fence firmly to the work-
piece to cut parallel line.
Cutting circles
1. If cutting away a section, make a drill
hole on workpiece to let the jigsaw
blade pass through.
2. Align the pin hole of the rip fence with
the center of the circle, and then use
a nail or screw to hold the object in
place.
3. Without touching the workpiece, turn
on the power switch.
4. Cut along the marked line.
Control PanelControl Panel
(1) (3)
(2)
(1) LED light
Before the use of LED
light, always pull the
power switch once.
Press the LED
light button.
The light illuminates
with very low cur-
rent, and it does not
adversely affect the
performance of the
driver during use or
its battery capacity.
CAUTION:
• The built-in LED light is designed to il-
luminate the small work area tempo-
rarily.
• Do not use it as a substitute for a reg-
ular flashlight, since it does not have
enough brightness.
• LED light turns off when the tool has
not been used for 5 minutes.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or perform-
ance of procedures other than those spec-
ifi ed herein may result in hazardous radia-
tion exposure.
-
14
-