Code No.
Content
Cause and solution
**1002 SD memory card
memory full
Data cannot be written as the memory of the SD memory card
has been exhausted. Delete some data in the SD memory card
or prepare a new SD memory card.
**1003 SD memory card
reading error
The data in the SD memory card cannot be read.
Check whether the saved data in the SD memory card is not
damaged with a PC.
**1005
SD memory card
saved file name error
The file name to be saved to the SD memory card from the GT
is not specified properly. Specify the file name properly.
**1006
SD memory card
recognition error
The SD memory card cannot be recognized.
Check the SD memory card used.
**1020
PLC model unmatch
error
Check if the PLC program for transfer matches the destination
PLC.
**1021
PLC model
unsupported error
The selected PLC model is not supported. Confirm the PLC
model.
**1022 Password protection
error
(1) Incorrect passwords were input three times or more. Input
the correct password after turning the power supply off and then
on again.
(2) The upload protection has been set for the PLC.
(3) The number of digits was changed when setting a new
password with the FP monitor function. Cancel the password
setting first to change the number of digits.
**1023 Master memory
installation error
A master memory is installed in the PLC (FP-X).Programs
cannot be transferred to the PLC with the master memory from
a SD memory card.
**1025
General-purpose
memory shortage
General-purpose memory shortage in the destination PLC.
**1027 Remote mode error
The PLC (FP2/FP2SH) is set to the RUN mode. Change to the
REMOTE mode or PROG. mode.
**102D Forced operation error
Check if a device that cannot be forcibly operated in the PROG.
mode has been forcibly turned on or off.
**1040
The record area for
logging was
overwritten.
A SD memory card is not inserted.
Check the SD memory card slot.
**1041
Data cannot be written into the SD memory card. Check whether
the SD memory card is not write-protected.
**1042
As the memory of the SD memory card has been exhausted.
Delete some data in the SD memory card or prepare a new SD
memory card.
**1044
The setting to stop writing to SD memory card has been set.
Cancel the writing stop setting.
**1043
SD memory card
writing error
The setting to stop writing to SD memory card has been set.
Cancel the writing stop setting.
**1045
The record area for
logging cannot be
reserved in the
SRAM.
Transfer all data.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net