Panasonic GT01 2.3 Connecting to Screen Creation Tool GTWIN

2.3 Connecting to Screen Creation Tool GTWIN

Pin No.

Name

Abbre.

Signal direction

1 Signal ground SG -

2 Send data SD GT→External device

3 Receive data RD GT ←External device

4 Not connected N.C. -

5 +5 V (+5V) -

Note:

• The +5V of Pin 5 is reserved for the FP Programmer II. It should not be used for any other application.

If using it, there is a restriction on the ambient temperature. The pin 5 of GT01 is N.C.

USB connection

Communication with our software such as GTWIN becomes available by connecting to a PC with a USB

cable.

Functions enabled by USB connection

• Through function using our PLCs

• Screen transfer (The communication in a speed approximately 3 times of the one with the Ethernet

connection is possible.)

Note: If more than one programmable display unit or AE20 are connected to a PC using the USB

port, the communication is not available.

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net