Replacing the front panel protective sheet (For the type without protective film)
1. Remove the peel-off film attached to the front panel protective sheet.
2. Attach the front panel protective sheet.
Attach the front sheet to fit the liquid crystal part of GT. At this time, try not to allow the air to get in the
attached face. If the air was in, remove the air to be out with fingers. Do not press the front panel hard as
it may cause the damage to the touch switch.
If the panel is being detached from the GT and then reattached, the waterproof packing should be
replaced, in order to assure that the panel remains waterproof (IP65, however, IP67 for GT02, GT12 and
GT32-E).
Replacing the waterproof packing
1. Remove the currently attached waterproof packing.
Remove the attached waterproof packing from the GT.
2. Attach the provided waterproof packing.
Take out one of the replacement waterproof packing pieces and attach the outer edge as shown in the
illustration (do not use the inner edge).
When doing this, fasten it to the front frame, being sure not to twist the waterproof packing.
As for the model with a grooved front frame, surely fit the waterproof packing in the groove.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net