- 126 -
To use the Wi-Fi function, connect this unit to a wireless access point or smart phone via Wi-Fi.
∫About the status indicator and the connection status icon when
connected to Wi-Fi

Connecting to a wireless access point

Check if the wireless access point you are using is compatible with WPS
jIf the wireless access point is compatible with WPS:
Proceed to the following [Easy Connection (WPS)]
jIf the wireless access point is not compatible with WPS:
[Manual Connection] (l128)
≥WPS is an abbreviation for Wi-Fi Protected Set up™
∫If this is the first time the Wi-Fi button is pressed
1Press Wi-Fi button.
2Touch [YES].
3Touch [Easy Connection (WPS)].
4Set the wireless access point to waiting for WPS.
≥For further details, please read the operating instr uctions for the
wireless access point.
≥A message is displayed when the connection is complete.
≥A message is displayed when the connection attempt fails. Touch
[EXIT], and set the connection again.
Wi-Fi [HC-V520]/[HC-V520M]
Connecting to Wi-Fi
If the clock has been set for the first time, the confirmation message for the Wi-Fi settings will be
displayed. Touch [YES], and then configure the access point settings below.
ALit green
≥
The status indicator is lit green while this unit i s connected
to a destination device after completing a Wi-Fi connection.
≥When Wi-Fi is disconnected, the status indicator is l it
red again.
BThe connection status icon
When connected to wireless access point:
connected to Wi-Fi/ not connected to Wi-Fi
≥The display will change as follows according to the
radio wave intensity: # # # .
When directly connected:
connected to Wi-Fi/ not connected to Wi-Fi
[Easy Connection (WPS)]