- 150 -
If you set [ON], the LCD monitor turns off when remotely operating th is unit with a smartphone (in
Motion Picture Recording Mode or Still Picture Recording Mode) so that power consumption is
reduced.
When the LCD monitor is turned off, you can display the screen by touching it.
If the Wi-Fi connection is turned off, this unit will turn off automatically approximately 30 minutes
later.
This will set/clear the Password to limit the startup of the Wi-Fi setting menu.
By setting the Password, it will prevent erroneous operation, prevent wrongful use of the Wi-Fi
function by third party, and protect the set personal information.

1Touch [Setup].

2Touch [INPUT], and enter the Password (6 characters).

After finish entering the Password, touch [Enter].
If the Password has already been set, is displayed.
For details on how to enter characters, refer to page 65.

3Touch [NEXT].

4Touch [INPUT], and enter the same Password again.

After finish entering the Password, touch [Enter].
If the Passwords match with each other, a message is displayed.

5Touch [EXIT].

If you set the Wi-Fi Password, you will need to enter the Password each time you touch [Wi-Fi
Setup] on the Wi-Fi home screen.
When you forget your Wi-Fi password, perform [Reset W i-Fi Settings] from the Setup menu. This
will set the Wi-Fi setting to the condition at the time of purchase, and you will be able to use the
Wi-Fi setting menu. (l36)
This item allows you to use NFC to turn on this unit, establish a remote connection, and configure
the home monitoring settings.
You can change the Wi-Fi setting back to the default condition.
The “LUMIX CLUB” Login ID and Wi-Fi password are a lso deleted.
[ECONOMY (Wi-Fi)] [ON]/[OFF]
[Menu Password] [Setup]/[Delete]
[Start up using NFC] [ON]/[OFF]
[Reset Wi-Fi Settings]