Panasonic HDC-SD9PC manual Quick Guide, ∫Charging the battery, ∫Inserting the battery

Quick Guide

∫Charging the battery

Charging lamp [CHARGE] A

Lights up:

Charging

Goes off: Charging completed

1Connect the AC cable to the AC adaptor and the AC outlet.

2Insert the battery into the battery charger by aligning the arrows.

∫Inserting the battery

Open the LCD monitor and install the battery by inserting it in the direction shown in the figure.

AInsert the battery until it clicks and locks.

∫How to turn on the power

Turn on the power by sliding the

mode switch to or while pressing the lock release button A.

12

≥Operate the mode switch while at the same time pressing in the lock release button if changing from OFF to another mode.

≥Status indicator B

≥To turn off the power, set the mode switch to OFF.

∫Inserting/removing an SD card

SD CARD

OPEN

Card access lamp [ACCESS]

≥When this unit is processing data, the access lamp A lights up.

1Set the mode switch to OFF.

2Open the SD card cover while sliding the SD CARD OPEN lever B.

3Insert/remove the SD card.

≥When inserting an SD card, face the terminal side C in the direction shown in the illustration and press it straight in as far as it will go.

≥When removing the SD card, press the center

of the SD card and then pull it straight out.

4Securely close the SD card cover.

≥ Securely close it until it clicks.

∫Language selection

1)Press the MENU button, then select [LANGUAGE] and press the cursor button.

2)Select [English] and press the cursor button.

VQT1N45