Panasonic HDC-SD9P manual Connection and recognition, Connect this unit to the AC adaptor, Method

Setup 2 Connection and recognition

After the software applications are installed, this unit must be connected to the PC and be correctly recognized by the PC.

≥Remove the supplied CD-ROM from your PC.

AUSB cable (supplied)

1 Connect this unit to the AC adaptor.

≥If a battery is used, operation is not possible when this unit is connected to a PC.

≥Do not disconnect the USB cable or the AC adaptor while the card access lamp is on or

card access icon ( ) appears on the LCD monitor. Doing so may damage the data.

2 Turn on the unit.

≥This function is available in all modes.

3 Connect this unit to a PC.

≥Insert the USB connectors as far as they will go.

≥Do not use any other USB connection cables except the supplied one. (Operation is not guaranteed with any other USB cables.)

4 Select [PC CONNECT] and press the cursor button.

≥This unit is automatically detected by the PC.

≥When the unit is connected to a PC, the operation mode cannot be changed and its power cannot be turned off.

Disconnect the USB cable, before turning this unit off (l 103).

∫If the driver has not been recognized properly

Use the following methods to enable it to be recognized.

Method 1:

Turn off the unit and your PC once and try verifying again.

Method 2:

Remove the SD card and try verifying again.

Method 3:

Try connecting the unit to another USB port on your PC.

∫To disconnect USB cable safely

1Double click the ( ) icon in task tray displayed on the PC.

≥Depending on your PC’s settings, this icon may not be displayed.

2Select [USB Mass Storage Device] and click [Stop].

3Verify [MATSHITA HDC-SD9/SD USB Device] is selected and click [OK].

103

VQT1N45