15
If you need to remove the KX-P8415 software,
perform the following steps.
Click Start , move the pointer to
Programs, Panasonic and Panasonic
KX-P8415.
Click Uninstall printer driver and
utility.
Click Yes .
After uninstallation, restart your
system.
Turn the printer on, then the computer.
The Ready indicator on the printer starts blinking.
After approximately 3.5 minutes, “Ready” is
displayed on the printer LCD panel.
The LCD will darken to save energy when the printer
is idle for 30 minutes.
It is possible to confirm the printer's setting by
printing the configuration page.
Press the MENU/EXIT button to enter
the Menu Mode.
Press the H/ENTER button.
Press the ▲/CONTINUE button.
Press the H/ENTER button.
BThe printer will start printing a Configuration
Page.
1
2
3
Removing the KX-P8415SoftwarePower OnPrinting a Test Page fromthe Printer Panel1
2
3
4
Configuration Page
Printer name: Panasonic KX-P8415
Printer Information Network Information
Controller FW Version: xxxx General Information
Engine ROW Version: xx Ethernet Card Not installed
Memory size 32 MB MAC Address 00:00:00:00:00:00
Auto Duplex Unit Not installed Hardware Rev Version: 0.00
Software Rev Version: 0.00
Bias Adjustment
Offset 0 TCP/IP
CYAN 0 Protocol Disable
MAGENTA 0 DHCP Disable
YELLOW 0 IP Address 0. 0. 0. 0
BLACK 0 Subnet Mask 0. 0. 0. 0
Gateway 0. 0. 0. 0
Maintenance Banner Page Disable
Page Count
Color 0 Netware
Monochrome 0 Protocol Disable
Toner Cartridge
CYAN XX % remaining Polling Internet 0 seconds
MAGENTA XX % remaining Bindery Enable
YELLOW XX % remaining
BLACK XX % remaining NDS
Imaging Unit XX % remaining Tree
Charge Unit XX % remaining
Transfer Unit XX % remaining
Fuser Unit XX % remaining Context
Oil Roll XX % remaining
Cleaning pad XX % remaining
Imaging Area
Last
CYAN 0 %
MAGENTA 0 % Adjustment to Media
YELLOW 0 % Plain Paper 0
BLACK 0 % Transparency 0
Average Label 0
CYAN 0 % Coated Paper 0
Envelope 0
Card 0
Frame Types Auto
Menu Mode
Test Page
Test Page
Configuration Page
Setup
Setup Guide
4