24
Replace the oil supply roll into the fuser unit.
Press down firmly on the oil supply roll to snap
both sides into place.
Open the front door and slide the fuser unit
back into the printer (Refer to the illustration
on step 2).
Turn the small green thumbscrew clockwise to
lock the fuser unit.
Close the front door.
Note:
•The error message “Jam at C” is cleared by sliding
out the fuser unit, then sliding it back to the printer.
#Open the access door (above the plastic
output tray).
$Remove the jammed media.
Open and close the front door to clear the
error message from the LCD.
OR
Perform steps 1 through 5 of Jam at G, H
(see below).
Remove the auto duplex printing unit.
Open the lid of auto duplex printing unit while
squeezing the green knobs.
Remove the jammed paper.
Close the lid and press down firmly on it to
snap both sides into place.
Reinsert the auto duplex printing unit.
6
Oiled cloth
If the oiled cloth is
loose, rotate the gear
(A) clockwise until it is
tight. Do not touch the
oiled cloth.
(A)
7
8
9
1
#
$
Jam at F
2
1
Jam at G, H
1
2
3
4
5