Extension Connection
Wire Specification The wire specifications are as follows:
Wire
Diameter of conductor
Solid wire
ø 0.4 – ø 0.65 mm
| Diameter with coating | ø 0.66 – ø 1.05 mm |
Connection | Use a | |
| There are 6 plugs to connect extensions to EXTN. 1 through EXTN. 6 | |
| jacks. |
|
1.Lift the transparent part.
2.Insert the required telephone wires into the holes of the plug. Then press the transparent part back into the black part.
Note: Do not strip the wires.
Insert the wires all the way into the plug.
For a proprietary telephone
H
A
B
L
| DOOR |
|
| OPENER |
|
| EXTN. | EXTN. |
| 5 | 6 |
| EXTN. | EXTN. |
| 3 | 4 |
| EXTN. | EXTN. |
| 1 | 2 |
SYSTEM | CO 2 | DPH |
| CO 1 |
|
For single line telephones
A
B
EXTN. |
|
|
| H |
|
|
| A | |
|
|
|
1
B
L
GROUND
To extensions
Notes
•A facsimile must be connected to EXTN.6 jack if an optional DISA/FAX Detect card (KX- T20691) is installed. See page 16 to install the card. System programming is also required. The “#12 Fax Connection” program should be assigned as “ENABLE”. See page 25. The “#24 Call Incoming Mode Selection” program should be assigned as “DISA”. See page 28.
•The EXTN.1 through EXTN.6 jacks correspond to extension numbers 21 through 26 respec- tively.
•You can use cable holders to fix the wires.
13
