Battery Replacement, Battery Precautions | Panasonic KX-T2378JXW

PQQX13204YA-03 01.11.28 8:36 AM y [ W 32

Battery Replacement

If “ ” ﬂashes, the battery power is low. Install new batteries. Replace the batteries within 1 minute to keep the programmed settings. But the programmed time setting will be cleared.

1	Disconnect the telephone line cord
1	from the unit.		-
			+
		+	-
		-
			+
2	Press down in the direction of the	2
	arrow and open the cover.	2
	arrow and open the cover.		1
3	Replace the batteries with new ones
3	using correct polarity (i, j), and

close the cover.

4 Connect the telephone line cord to the unit.

³If the time is shown as “12-00” and “ readjust the time.

” ﬂashes after replacing the batteries,

Battery Precautions:

The batteries should be used correctly, otherwise the unit may be damaged by battery leakage.

—Do not mix different types of batteries.

—Do not charge, short-circuit, disassemble, heat or dispose of in ﬁre.

—Remove all the batteries when replacing.

Note:

—If you do not install the batteries or if the battery power is low, the time will be shown as “12-00” and “ ” will ﬂash. Readjust the time.

—Replace all the batteries once a half year in use of Alkaline batteries, or misoperation may occur. (When you use Manganese batteries, replace all of them once in three months.)

—Do not use nickel-cadmium batteries.

32

Image 32

Panasonic KX-T2378JXW operating instructions Battery Replacement, Battery Precautions

Contents

Model No. KX-T2378JXW Accessories included Before Initial UseFor your future reference Serial No Date of purchase Contents Indicator p , 17 VolumeLocation of Controls Buttons p MIC Microphone p , 17 Mute Button p Hold Button p Pause Button p Redial Button p Flash Button p One-Touch Auto Dial Buttons p Tone Button p Display pButton p Display Settings Installing the BatteriesConnecting the Handset Press down in the direction Arrow and open the cover Connecting the Telephone Line Cord To connect a two-line telephone jackTo connect two single-line telephone jacks Connect the telephone line cords to the unit as follows Connecting a Communication Device If you use the unit only as a single-line telephone Press Program to store the setting Programming Summary of PreparationsMake sure that a call is not put on hold Press Mute Selecting the Dialing Mode To select Pulse, press2 To select Tone, press1 Time Adjustment You can select AM/PM or 24-hour clock by programming Setting the LCD Contrast Selecting the Ringer VolumePress Press 1 to Locks, so the tab holds the handset Wall MountingWall Template Making Calls Using the handsetUsing the speakerphone To redial the last number dialed To put a call on holdTo release the hold Automatic Redial What the line indicator means Answering Calls Using the Other Line During a Conversation Ex If you are using LINE1 During a conference call Ex If you are using LineConference Call Speed Dialer Storing Phone Numbers in MemoryEnter a phone number, up to 22 digits Press a memory station number 0 to Dialing a Stored Number To erase a stored number Press one of the one-touch auto dial buttons One-Touch DialerTo store in an Upper memory location Memory location, press the one-touch To store in a Lower memory locationIf the phone number is in an Upper Memory card From an Upper memory locationFrom a Lower memory location Special Features For Call Waiting Service UsersHow to Use the Pause Button Temporary Tone Dialing Muting Your Conversation Flash ButtonSelecting the ﬂash time Press Mute while talking Setting the PIN Code Enter a new PIN code using a 4-digitEnter the current PIN code Ex is entered To cancel the dial lock Dial LockTo set the dial lock Enter the PIN code p Enter the PIN code p Ex. Your PIN code is Call RestrictionTo set the call restriction Connecting the Optional Headset to the Unit Using the Optional HeadsetTo cancel the call restriction Making/Answering Calls Make sure to install the batteriesTo adjust the headset receiver volume 4 levels Battery Replacement Battery Precautions Problem Remedy Before Requesting Help ProblemRemedy Before Requesting Help Safety Instructions Installations Environment 62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan PQQX13204YA F1001-1111D