Useful Information
The handset stops working while being used.
LDisconnect the base unit AC adaptor and turn off the handset. Connect the AC adaptor, turn on the handset and try again.
While storing an entry in the phonebook or assigning a hot key, the handset starts to ring.
LA call is being received. To answer the call, press {C}. Programming will be cancelled. Start again.
Pressing -does not display/dial the last number dialled.
LIf the redialled number was more than 24 digits long, the number will not be redialled. Redial the number manually.
The handset beeps intermittently and/or
7flashes.
LFully charge the battery (page 9).
I fully charged the battery, but 7still flashes.
LClean the charge contacts and charge again (page 9).
LIt is time to replace the battery (page 10).
Caller information is not displayed.
LYou must subscribe to Caller ID service.
While viewing caller information, the display returns to standby mode.
LDo not pause for over 1 minute while searching.
Audible call sounds late.
LThe audible call announcement is too long. Record a shorter announcement (page 19).
When searching the handset phonebook by voice, the wrong entry is displayed.
LThe voice tag is too similar to another voice tag. Record a different voice tag for one of the entries (page 17).
I cannot register a handset to a base unit.
LThe maximum number of base units (4) are already registered to the handset. Cancel unused base unit registrations from the handset (page 42).
LThe maximum number of handsets (6) are already registered to the base unit. Cancel unused handset registrations from the base unit (page 41).
LYou entered the wrong PIN number. If you forget your PIN, consult your nearest Panasonic service centre.
LLocate the handset and the base unit away from other electrical appliances.
Answering system (KX-TCD580 only)
The answering system is turned on, but caller messages are not recorded.
LThe recording time is set to “Greeting
Only”. Select “1 Minute” or “No Limit” (page 40).
LMessage memory is full. Erase unnecessary messages (page 36).
I cannot operate the answering system with the handset.
LAnother handset user is using the answering system, accessing the Caller ID list or changing base unit settings. Wait for the other user to finish.
LA caller is leaving a message. Wait for the caller to finish.
LThe handset is too far from the base unit. Move closer.
52
