➡
40
◆Setting the Handset PIN
You can program a 4 digit password for the handset. The factory pre-set is 0000.
Changing the password may prevent the unauthorised use of your unit by another person.
S/UYor V S/U Yor VEnter Old PIN Enter New PIN
Select
‘Other
Option’
Select
‘Change
Hset PIN’
Enter the current
4-digit handset
PIN.
In the ‘Setting Handset’mode
Enter the new 4-digit
PIN TWICE.
If 2nd PIN entry is
incorrect, an error
tone sounds and
display returns to
‘Enter New PIN’. If
PIN is correct, a
confirmation tone
sounds.
NOTE: Once you have programmed the password, you
cannot confirm it. We recommend you write down the
password. If you forget it, please consult your nearest
Panasonic Service Centre.
◆Registering a Handset to a Base Unit
The handset supplied with the base unit is already registered. If an optional
handset/base unit is purchased, the following procedure needs to be carried out before
initial use.
Zand hold (Ï) on base unit for more than10 seconds.A series of beeps begin
to sound.
NOTES:
• Charge the optional handset batteries for about 10 hours before initial use.
• Register the handset number within 1 minute. If not registered within 1 minute,
ZP on the handset to cancel the programming mode. Then re-start registration.
• Calls (both incoming and outgoing) can be conducted only via the displayed base
unit (even if the radio areas overlap with neighbouring base units).
S/UYor V S/U Yor VS/UYor VPlease Wait...
Select
‘Registration’
Select
‘Register
H/set’
Select Base
No. to register
handset (1-4).
In the ‘Setting Handset’mode
Handset searches
selected base.
Enter Base PIN Yor VPlease Wait...
• If registration is successful, a confirmation tone
sounds and display returns to the standby mode.
The selected base number is displayed in the
standby mode.
• If registration is not successful within 5 minutes, an
error tone sounds and display returns to original
standby mode.
KX-TCD705_HongKong 12/7/01 2:29 pm Page 40