◆Making a Call
(For further information on making calls, see pages 13-16)
1. ZO or %.
2. Dial a phone number (maximum 24 digits)
The dialled number is displayed.
(If a number is entered incorrectly,ZP).
After a few seconds, the display will start showing the length of the call.
12
◆Terminating a Call
1. To hang up,ZP.
•After a few seconds, the display returns to the standby mode.
• If the handset is placed on the base or charger during a call, the call is
disconnected.
•The dialled number is stored in the redial memory.
◆◆Turning the Power On
1. Zand hold P
•Aconfirmation tone sounds.
•All possible configurations briefly appear.
• When button is released, the display will change to the standby mode.
➀The current connected base unit number is displayed
• You can choose whether to display the base unit number, handset number or no
display in the standby mode (see page 38).
➁The number of New Caller ID calls received are displayed.
Basic Start-up Operations◆Answering a Call
(For further information on answering calls, see page 17.)
During Incoming call:
1. ZO
•You can also answer a call by pressing any dialling button Kto I, $, L
or N(-Any Key Answer).
Or Z%and when the other party answers, talk into the microphone.
After a few seconds, the display will start showing the length of the call.
◆Turning the Power Off
Make sure that the unit is in the standby mode.
1. Zand hold Puntil a long beep sounds.
• The display will go blank. (On location of the handset in the base unit, the battery
icon will display even after power off).
Base 1
10 New Calls
ÎÏÔÍÁ Ò
➀
➁
Note: Zshows that you should press the following key(s).
30678_KX-TCD705 Dutch_a_English 22/6/01 9:22 am Page 12